Dinstar DAG1000-4FXS, Руководство пользователя, Страница: 15 / 34

Page 13
Call Features
The DAG serial supports all the traditional and advanced telephony features.
T
ABLE
5: DAG serial CALL F
EATURE
D
EFINITIONS
*47
Direct IP Calling.
Dial “*47” + “IP address”. No
dial tone is played in the middle. Detail see
Direct IP Calling section on page 9.
*50
Disable Call Waiting (for all subsequent calls)
*51
Enable Call Waiting (for all subsequent calls)
*72
Unconditional Call Forward:
Dial “*72” and then the forwarding number followed by “#”.
Wait for dial tone and hang up. (dial tone indicates successful forward)
*73
Cancel Unconditional Call Forward.
To cancel “Unconditional Call Forward”, dial “*73”,
wait for dial tone, and then hang up.
*78
Enable Do Not Disturb (DND): When enabled all incoming calls are rejected.
*79
Disable Do Not Disturb (DND): When disabled, incoming calls are accepted.
*87
Blind Transfer
*90
Busy Call Forward:
Dial “*90” and then the forwarding number followed by “#”. Wait
for dial tone then hang up.
*91
Cancel Busy Call Forward.
To cancel “Busy Call Forward”, dial “*91”, wait for dial tone,
and then hang up.
*92
No Answer Call Forward.
Dial “*92” and then the forwarding number followed by “#”. Wait
for dial tone then hang up.
*93
Cancel no Answer Call Forward. To cancel no Answer Call Forward,
dial “*93”, wait for
dial tone, and then hang up.
*99 Cancel All Call Forward
*114# Report Phone No.
*158# Report IP Address
*111# Reset
Flash/Hook
Toggles between active call and incoming call (call waiting tone). If not in conversation,
flash/hook will switch to a new channel for a new call.
SENDING AND RECEIVING FAX
DAG serial supports fax in two modes: 1) T.38 (Fax over IP) and 2) fax pass through.
T.38 is the preferred method because it is more reliable and works well in most network conditions. If the
service provider supports T.38, please use this method by selecting T.38 as fax mode (default). If the
service provider does not support T.38, pass-through mode may be used. If you have problems with
sending or receiving Fax, toggle the Fax Tone Detection Mode setting.