Dingo Tools 65CC, Скачиваемая инструкция пользователя, Страница: 9 / 9

9
AIR FILTER
Never run engine without aircleaner properly installed. Added wear and engine failure may occur if air cleaner is not installed.
Service air cleaner every 3 months or after 20 hours of operation. Clean filter in extremely dusty conditions.
STEPS FOR CLEANING AIR FILTER
1.
Wash in warm water with mild soap until dirt and debris are removed. Press filter when washing do not twist.
2.
Rinse in warm water until soap and dirt are removed.
3.
Dry filter by wrapping in a clean cloth and pressing filter until it is dry.
4.
Apply oil to the entire filter.
5.
Remove excess oil.
6.
Attach the filter and air cleaner cover to the engine.
CHECKING SPARK PLUG
1.
Check spark plug every 50 operating hours
2.
Disconnect the spark plug cap, and clean any debris from around the spark plug area.
3.
Remove spark plug and replace if any of the following occur, pitted electrodes, burned electrodes, cracked porcelain, or
deposits around electrodes.
4.
After analysis, seat spark plug and tighten with spark plug wrench.
CARBURETOR
Never tamper with factory setting of the carburetor.
TRANSPORTING YOUR EARTH AUGER
1.
Never transport engine inside an enclosed space of vehicle. Fuel or fuel vapors may ignite causing serious injury or death.
2.
If fuel is present in the fuel tank , transport in an open vehicle in an upright position.
3.
If an enclosed vehicle must be used, remove gas into an approved red fuel container. DO NOT siphon by mouth.
4.
Run engine to use up the fuel in the carburetor and fuel tank. Always run engine in a well ventilated area.
5.
Wipe away any spilled fuel from engine and earth auger. Alow to dry.
LONG TERM STORAGE
If your earth auger will not be used for more than one month, prepare it for long term storage.
STEPS FOR LONG TERM STORAGE
1.
Add fuel stabilizer according to manufacturer’s instructions.
2.
Run engine for 10-15 minutes to ensure that the stabilizer reaches the carburetor.
3.
Remove the remainder of the fuel from the gas tank into an approved fuel container.
4.
Remove auger from powerhead and apply a thin layer of grease to the output shaft.
5.
Store auger and powerhead (engine) in a vertical position.
6.
Remove all debris from auger and powerhead (engine).