8
WARM ENGINE START
1.
Open gas cap vent screw all the way (counter clockwise)
2.
Move choke lever to CHOKE or ON position
NOTE:
CHOKE position is defined by moving the choke lever as far to the ON position as possible.
3.
Continue with Step 5 of Cold Engine Starting
HOT ENGINE START
1.
Open gas vent screw al the way (counterclockwise)
2.
Continue with Step 5 of Cold Engine Starting
3.
If engine does not fire, refer to Step 2 of Warm Engine Starting
DO NOT USE STARTING FLUID DO NOT SPRAY FLAMMABLE LIQUIDS OR VAPOURS INTO AIR CLEANER, CARBURETOR OR SPARK PLUG CHAMBER.
DO NOT REMOVE SPARK PLUG AND PULL ON STARTER ROPE. FLAMMABLE FUEL CAN SPRAY OUT AND IGNITE FROM A SPARK FROM SPARK PLUG.
MAINTENANCE AND STORAGE
AUGER MAINTENANCE
1.
The gear case has 4 oz of grease installed at the factory. It is recommended that once a year the gear case be split and the
grease level checked. Add grease only if level of grease is below top of the gears.
DO NOT OVERFILL
2.
Keep all screws, nuts and bolts tight.
3.
For cold weather operation, store the unit in a cool environment. Transferring the unit from a warm to a cold place can cause
the build up of harmful condensation.
4.
If blade performance decreases, turn unit off and disconnect spark plug wire. Carefully inspect cutting edge of blade for any
signs of wear. If blades show any of these signs, they need to be sharpened or replaced.
COOLING FINS
Cooling fins, air inlets and linkages must be free from any debris before each use.
Содержание 65CC
Страница 1: ...1 ...
