DINGLI JCPT2223RTA, Руководство оператора с информацией по обслуживанию

Страница: 32 / 75

OPERATOR’S MANUAL
with Maintenance Information
Function Tests
25
platform.
49 Fully lower the platform.
50 Drive the Left front wheel onto an 18cm
block.
51 Raise the platform at least 3.5 m.
52 Press the drive function select button
53 Activate the proportional control handle in
the direction indicated by the yellow arrow
⊙
Result: The left front or right rear wheel
remains elevated in position off ground
54 Press the lift function enable button.
55 Lower the platform to stowed position,
activation drives forward and backward
moving machine.
⊙
Result: Lockout cylinders should release
and allow wheel to rest on ground
56 Drive the right front wheel onto an 18cm
block.
57 Raise the platform at least 3.5 m.
58 Press the drive function select button
59 Activate the proportional control handle in
the direction indicated by the yellow arrow
⊙
Result: The right front or left rear wheel
remains elevated in position off ground
60 Press the lift function enable button.
61 Lower the platform to stowed position,
activation drives forward and backward
moving machine.
⊙
Result: Lockout cylinders should release
and allow wheel to rest on ground
Test the Up Limit Switch and the
Outriggers
62 Push and hold the lift function enable
button. Raise the platform.
⊙
Result: The platform should rise to 12 m
and then stop. The platform should not rise
above 12 m unless the outriggers are
lowered.
63 Press the drive function select button.
Drive the machine forward.
⊙
Result: The drive function should operate.
64 Press the lift function select button.
65 Lower the platform. If the platform is higher
than 3.5 m from the ground, the outriggers
will not lower.
66 Lower the platform to the end.
67 Push and hold the auto level button.
68 Press and hold the function enable switch.
Activate the proportional control handle in
the direction indicated by the yellow arrow.
The outriggers will extend and level the
machine. A beep will sound when the
machine is level.
69 Raise the platform.
⊙ Result: The platform should rise to full
height.
70 Lower the platform.
Test Auxiliary Lowering
71 Push and hold the function enable button
and raise the platform approximately 60
cm.
72 Press the engine start/ flameout button to
engine off.
73 Push and hold the function enable button.
Activate the control handle in the direction
indicated by the yellow arrow.
⊙
Result: The platform should lower.
Test Platform Telescopic Functions
74 Push and hold the Platform retractable
enable button. Press and hold the function
enable switch. Activate the proportional
control handle in the direction indicated by
the blue arrow