Dimplex WI 40CG, Инструкция по установке и эксплуатации

Страница: 3 / 36

3
PLEASE READ IMMEDI-
ATELY
1.1 Important notes
During transport the heat pump must
not be inclined to any side by more than 45°.
The heat pump is not attached to the
wooden grating.
Disconnect all voltage supplies prior
to opening the unit.
Service of the heat pump must be
performed by authorized and experienced
service personnel only.
The working fluid R407C is free of CFC,
does not disturb ozone and is non-combustible.
Ensure the clockwise rotating field
when connecting the supply cable.
The covering hood can not be painted.
The well water must be of the water
quality specified.
The startup procedure must follow the
Installation and Operanting Instructions for the
heat pump control.
PLEASE READ IMMEDIATELY
CAUTION !
CAUTION !
CAUTION !
CAUTION !
CAUTION !
CAUTION !
After cleaning it is essential to neu-
tralize the system by suitable means in order to
prevent secondary damages to the heating
system.
The heat pump is not intended to meet
the increased heat requirements of de-humidi-
fying a building. Therefore it is necessary to use
dedicated equipment provided by the client to
generate the extra amount of heat needed for that
purpose.
1.2 Legal requirements and guide-
lines
The heat pump complies with all relevant DIN/
VDE regulations and EEC directives. These are
listed in the attached CE conformity statement.
Electric wiring of the heat pump must comply with
the applicable VDE, EN and IEC standards.
Furthermore, the electrical supply conditions
stipulated by the power provider must be
observed.
The heat pump must be interconnected with the
heat source and the heating system in compli-
ance with the relevant regulations.
Service of the heat pump must be
performed by authorized and experienced
service personnel only.
1.3 Energy-saving heat pump opera-
tion
By operating this heat pump you contribute to the
protection of our environment. Proper dimen-
sioning of the heating system and the heat source
are of prime importance for the efficiency of heat
pump operation. Low water inlet temperatures
are of particular importance. Therefore, all con-
nected heat consumers must be suitable for low
water inlet temperatures. An increase in the
heating water temperature by 1 K causes an
increase in the electrical power consumption by
approx. 2.5%. An underfloor heating system with
forward temperatures between 30 and 40 °C is
particularly well suited for energy-saving oper-
ation.
1
CAUTION !
CAUTION !
CAUTION !
CAUTION !
CAUTION !
CAUTION !