4
diameter of between 1 - 2 inches (25 - 48 mm). (Figure 2-B)
3. Slip Mounting Part B back onto the heater body and fit it to the
Mounting Part A from the
bottom, sliding up. (Figure 2-C)
4. Secure the heater to the
umbrella pole by turning the
locking screw (Figure 1)
clockwise until tight and the
heater remains in place.
5. Using the handle at the end of
each heater panel, pull each
panel upwards until a click is
heard. This indicates the
panel is locked in position.
(Figure 3)
6. To fold any of the panels back
down, refer to Figure 4 when
following these steps.
i) Lift the panel upwards until it clicks.
ii) While holding the panel in place, press in the metal Release
Button located at the side of each panel with a free hand.
(Figure 4)
CAUTION:
To avoid damage to the heater, do not attempt to
fold panels down without pressing in the Release Button.
Figure 3
Handle
Figure 4
i) Push up
ii) Press in to release
iii) Fold down
