12
DF3015
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLAME MOTOR/REFLECTOR ROD
1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side of trim.
3. Slide glass to right side of fireplace to remove.
4. Pull the front edge of the plastic ember bed or plastic grate up and forward until the
rear tab releases from the ledge located at the bottom of the mirror.
IMPORTANT: Only handle the logset by the ember bed.
NOTE: Logset fits tightly into firebox, some force may be necessary to remove.
5. Set logset in front of fireplace.
6. Disconnect the logset LED wire harness from unit.
7. Disconnect the flicker motor wiring connector from the circuit board.
8. Remove the reflector rod from the flicker motor by pulling the end of the rod to the
left and cut the reflector spring with wire cutters. DO NOT TAKE THE LEFTOVER
SPRING OFF THE END OF THE REFLECTOR ROD
9. Remove the (2) screws securing the flicker motor to the flicker motor bracket.
10. Discard the old flicker motor.
11. Pick up the 1 ½” rubber sleeve and locate over remaining spring on reflector rod.
ENSURE TO LOCATE THE LARGE OPENING OF THE RUBBER SLEEVE OVER
THE REMAINING SPRING OF THE REFLECTOR ROD.
12. Reassemble in the reverse order as above.
