9
DF3015
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
Light bulbs need to be replaced when you notice a dark section of the flame. There are
four bulbs under the log set which generate the flames and embers. It is a good idea to
replace all of the light bulbs at one time if they are close to the end of their rated life.
Group replacement will reduce the number of times you need to open the unit to replace
the light bulbs.
TO REPLACE LOWER BULBS:
1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side of trim.
3. Slide glass to right side of fireplace to remove.
4. Pull the front edge of the plastic ember bed or plastic grate up and forward until the
rear tab releases from the ledge located at the bottom of the mirror.
IMPORTANT:Only handle the logset by the emberbed.
NOTE: Logset fits tightly into firebox, some force may be necessary to remove.
5. Set logset in front of fireplace.
6. Disconnect the logset LED wire harness from unit.
7. Hold the socket while unscrewing the old bulb.
8. Hold the socket while screwing in the new bulb.
9. Reassemble in the reverse order as above.
LIGHT BULB REQUIREMENTS
Quantity of 4 clear chandelier or candelabra bulbs with an E-12 (small) socket base,
60 watt rating.
