11
DF3015
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE MAIN ON/OFF SWITCH/SWITCH CIRCUIT BOARD
1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side of trim.
3. Slide glass to right side of fireplace to remove.
4. Pull the front edge of the plastic ember bed or plastic grate up and forward until the
rear tab releases from the ledge located at the bottom of the mirror.
IMPORTANT: Only handle the logset by the ember bed.
NOTE: Logset fits tightly into firebox, some force may be necessary to remove.
5. Set logset in front of fireplace.
6. Disconnect the logset LED wire harness from unit.
7. Remove the switch assembly by squeezing the retainer clips on the inside of the
fireplace and push out through the front
8. Disconnect the wiring clips and connections noting their original locations.
9. Remove the MAIN ON/ OFF switch by squeezing the retainer clips and push through
the font of the plastic housing.
10. Remove the SWITCH CIRCUIT BOARD by removing the 2 retaining screws.
11. Reassemble in the reverse order as above.
