Setting the ‘Desired’ Room Temperature
The temperature is set using the temperature increase
and temperature decrease
buttons. The room temperature
can be set in the range between 5°C to 30°C. Please note the temperature indicated on the display represents the
desired room temperature. It does not display the current room temperature.
Note -
If the temperature set is lower than the room temperature then the product will not emit heat. The temperature
display will be flashing to indicate this. The product is still actively controlling the room temperature and will
automatically turn back on if additional heat is required, i.e. the room temperature lowers or the set temperature is
increased higher than the room temperature.
Mode selection
Press enter
to confrim selection
and activate mode
Auto mode
Manual mode
Boost mode
•
With the appliance activated, press the
key to toggle through the operational modes.
•
Select the desired mode using the
key.
•
It will then be necessary to setup the selected mode. Auto mode is an exception as this mode must be pre-set
using the
key. See '
Auto Mode Setup
'
Note: If an Auto program has not been set, the Auto mode will not be visible/selectable when toggling through the
options.
Manual Mode Setup
•
To select Manual mode navigate to the mode using the
key and confirm selection using the
Key.
•
Use the
or
keys to select the desired heat setting (see
Heat Selection
for details) and confirm the selection
by pressing the
key.
•
The desired room temperature can be adjusted at any point during the Manual mode operation Use the
or
keys.
Frost Protection (Manual Mode)
Within the manual mode the appliance has a frost protection function. This
setting is useful in areas such as garages to assist in the prevention of frost
damage.
To activate this mode, while in
Manual Mode
set the temperature to its minimum
setting ‘5°C’, the frost protection symbol (
) will illuminate. When set, the heater
will cycle ON and OFF to try to maintain a temperature of approximately 5°C
and help protect against frost conditions.
It is normal for the 5°C to be flashing when this model is active, it will stop flashing
once heat is required e.g. if the room temperature drops below 5°C.
Note -
This appliance cannot guarantee total frost protection, external factors
such as room size, outside temperature, room insulation properties, etc. will
impact on the reliability of this mode.
.
