Standby & Power Up
When the appliance is plugged in there will be an audible beep and the unit will enter 'Standby' mode. The appliance
is now energised and ready for use.
First time start-up?
•
In the event of a power interrupt, plugged out/power cut/tilt switch operation, then reconnected the appliance
will return in Standby mode, once turned back on the product will return to last used settings.
Screen & Button Sleep Mode
If no buttons have been pressed for approximately 20 seconds, the display screen and buttons will enter sleep mode,
all buttons except the Standby will disappear. Selected screen icons will remain visible to indicate the active mode but
the brightness of the screen icons will dim 50%. To reactivate buttons, place your hand on the display.
The appliance will continue to function as required once the unit is in sleep mode.
Press the
Standby
button to turn the
product
On
YES
On first time start-up the product will start with the
default settings. The temperature will be set to 25
o
C
and the heat setting will be set to intelligent (Eco) heat
mode, see '
Heat Selection
' section.
Note -
For first time start up or in the event of a time
memory loss, if/when the
or
buttons are first
pressed the appliance will enter the time setting mode,
see '
Setting the time
'
NO
On subsequent start-ups the product will return to the
last used settings. Heat Selection, Temperature Settings,
temperature units and Sound settings will return as per
the previous operation. The Wireless connectivity will
automatically attempt to re-pair with the bonded device,
see '
Wireless Connectivity
'.
Boost mode will not reactivate, in this case the appliance
will return as per a first time Start up. The screen
below shows an example where the user previously set
Manual mode with the temperature set to 21
o
C and Heat
Selection to LOW, note time had been set and the sound
was turned off.
