Two Zone Wall Mounted Programmer
(only applicable if Programmer is
fi
tted to DuoHeat installation)
The programmer has two modes (i) AUTO or (ii) MANUAL
(i)
In “Auto” mode, the radiator will change between Comfort and Setback modes (as shown in the table below) depending on your
seven day programme. To change the programme settings or temporarily over ride the programme, see the appropriate programmer
instructions.
(ii)
“Manual” mode will override the auto programme setting. There are four “Manual” mode settings shown in the table below.
RX010006 - Pilot Wire, or
RX010007 - Mains Borne Signalling
H
J
Note:
It will take 24 hours for room temperature to reach a comfortable level when resetting
from “Setback”, “Frost Protect”, “Off” to “Comfort”.
Everyday Operation
Once the Background level has been set (see Achieving Optimum
Comfort Level above), this should not require any further
adjustment.
Adjust the Comfort setting as required to suit your comfort needs
and occupancy pattern. For a short period of non occupancy the
control can be lowered slightly (we recommend by no more than 2
bars) to save energy when the room is unoccupied and increased
again when more heat is needed.
Non Occupancy (vacant)
For long periods of non occupancy, reduce the
Background
and
the
Comfort
to their lowest settings.
It will take 24 hours for room temperature to reach a
comfortable level when resetting from Low settings to Normal
settings.
Child Lock Operation
To activate the child lock simultaneously depress the
+
and
-
buttons for a period of 3 seconds. After this period the child
lock is in operation and the LED will illuminate for short period and
then revert to the setback setting. The LED beside the key symbol
will illuminate while the child lock is in operation.
Once in the locked position, if either of the controls are operated
the LED will resume maximum illumination for a short period before
reverting back to the setback position.
To deactivate the child lock, depress the buttons simultaneously
again for 3 seconds and the buttons will become active.
Safety - Overheat Protection
For your safety, this appliance is
fi
tted with thermal cut-outs. In the
event that the product overheats, the cut-outs switch the radiator
off automatically. In the event of these safety cut-outs activating
please inform the installer or Dimplex Customer Services for advice
in order to reset the cut-outs.
Programmer Mode
Temperature Setting
DuoHeat Radiator –
“Temperature
control
display
setting”
Comfort Setting (radiator setting). Each
Comfort
Radiator will operate as set in “controls”
Display will remain as shown in Quick Start Guide
section
of
Operating
Instructions.
Setback will reduce the Comfort setting by
Display will show two red bars less.eg. if “Comfort”
Setback
2°C, and will leave the Background
displays 5, “Setback” will display 3 red bars.
unaffected.
Frost Protect
Room temperature will be maintained at
Display will show one red bar.
16°C
with
Background
operating.
This will completely switch off radiators,
Off
e.g. during the summer heating may not be
Display will show one red bar.
required.
