5
Gently pull the flicker rod to the right as far as possible
5.
into the rubber bushing on the flicker motor shaft (Figure
9).
Unscrew bulbs counter clockwise.
6.
Insert new bulbs.
7.
Reconnect the log set LED wire harness.
8.
Install the log set by placing the front, bottom edge of
9.
the ember bed in the track behind the front panel. Once
in place, push down on the back edge of the ember bed
until the rear tab snaps into place under the Partially
Reflective Glass (Figure 10).
!
NOTE:
Ensure the log set is installed tightly under the
back ledge to prevent light leakage.
Replace glass assembly.
10.
Upper Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs with
an E-12 (small) socket base, 15 Watt rating.
Do not exceed 15 Watts per bulb.
To access the upper light bulb area:
Remove front glass assembly.
1.
Upper bulbs are located in the upper left and upper right
2.
corners of fireplace (Figure 8).
Remove the upper light cover for each bulb (two (2)
3.
Philips screws each).
Unscrew bulbs counter clockwise.
4.
Insert new bulbs.
5.
Re-install upper light bracket.
6.
Replace glass assembly.
7.
Glass Cleaning
The glass is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc., the
glass may collect dust particles; these can be removed by
dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the glass can be
cleaned with a damp cloth. To prevent scratching, do not use
abrasive cleaners or spray liquids on the glass surface.
Figure 4
Upper Bulbs
Lower
Bulbs
LED
Wire Harness
Front
Glass
Media Tray
or
Log Set
(depending on model)
Back
Ledge
Log
Ember Bed
Rear
Tab
Front
Edge
Side Section
Figure 6
Figure 5
Exploded view to show detail
Flicker Rod
Flicker
Motor
Bulbs (3)
Flicker Motor
Shaft and rubber
bushing
Light Filter
Bracket
Screws to
remove
(2 per side)
Fireplace Surface Cleaning
Use a cloth dampened with warm water only to clean painted
surfaces of the electric fireplace. Do not use abrasive
cleaners.
