4
LOWER LIgHT BULB REQUIREMENTS:
MOD 0-A:
3 - 35 watt, 12 volt, Narrow spot Halogen bulb
DO
NOT EXCEED 35 WATTS PER BULB
Remove the light cover mounting screws located on the
1.
rear cover and remove the light cover being careful not to
damage any of the wiring or light bulbs.
Remove the burnt out bulb(s) by pulling straight out of
2.
socket. If bulbs are difficult to remove from socket move
the bulb from side to side while pulling being careful not
to damage the light socket.
Replace the upper light bulb.
3.
Reassemble in the reverse order as above.
4.
MOD B-D:
3 – 35 watt Halogen Quartz lamps, 120 volt, G9
base.
DO NOT EXCEED 35 WATTS PER BULB
Remove the stove pipe kit (if equipped).
1.
Gently place stove on its back on a flat surface.
2.
Remove the heater cover retaining screws located on the
3.
bottom of the stove and lower heater and light assembly
out onto the floor. (Figure 4)
Remove the burnt out bulb(s) by pulling straight out of
4.
socket. If bulbs are difficult to remove from socket move
the bulb from side to side while pulling being careful not
to damage the light socket.
Replace the lower light bulbs.
5.
Reassemble in the reverse order as above.
6.
gLASS CLEANINg
The clear door is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc., the
clear door may collect dust particles, these can be removed
by dusting lightly with a clean dry cloth.
To remove fingerprints or other marks, the clear door can
be cleaned with a damp cloth. The clear door should be
completely dried with a lint free cloth to prevent water spots.
To prevent scratching, do not use abrasive cleaners or spray
liquids on the clear door surface.
STOVE SURFACE CLEANINg
Use warm water only to clean painted surfaces of the
Compact Stove. Do not use abrasive cleaners.
Figure 4
Maintenance
WARNINg:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire, electric
shock or damage to persons.
LIgHT BULB REPLACEMENT
CAUTION:
Allow at least 5 minutes for light bulbs to cool
off before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark
section of the flame or when the clarity and detail of the log
exterior disappears. There are two bulbs under the log set
which generate the flames and embers.
Tools Required:
Flat head Screwdriver
Helpful Hints:
It is a good idea to replace all light bulbs at
one time if they are close to the end of their rated life. Group
replacement will reduce the number of times you need to
open the unit to replace light bulbs.
UPPER LIgHT BULB REQUIREMENTS:
MOD 0-C:
1 - 25 watt, 12 volt, 1156 Incandescent automotive
bulb.
DO NOT EXCEED 25 WATTS
MOD D:
1 –15 watt candelabra E12 small base 120 volt.
DO
NOT EXCEED 15 WATTS
Remove the stove pipe kit (if equipped).
1.
Remove the 2 screws at the upper corners of the back
2.
panel. (Figure 3) Lift the back end of the top to clear the
brackets and pull back. Lift top carefully, and place to
the side of the stove. Caution should be taken as the top
mounting brackets may scratch the finish.
Remove the burnt out bulb by pushing in and turning
3.
counter-clockwise.
Replace the upper light bulb.
4.
Reassemble in the reverse order as above.
5.
Figure 3
