3
A
B
C
D
Operation
To access the controls, go to the back of the stove.
A. ON/OFF SWITCH
The On/Off switch supplies power to all stove functions
(heater & flame).
B. LIgHT DIMMER CONTROL
Controls the light intensity of the log bed display area.
Rotate the knob to choose the desired setting.
C. HEATER SWITCH
The heater switch turns the heater function on and off.
D. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to turn on
the heater. When the room reaches the desired temperature,
turn the thermostat knob counter clockwise until you hear a
click. Leave in this position to maintain the room temperature
at this setting. For additional heat, turn clockwise until you
hear the click again and the heater will turn on.
RESETTINg THE TEMPERATURE CUTOFF
SWITCH
Should the heater overheat, an automatic cut out will turn the
heater off and it will not come back on without being reset.
It can be reset by switching the On/Off Switch to OFF and
waiting 5 minutes before switching the unit back on.
CAUTION:
If you need to continuously reset the heater,
unplug the unit and call Dimplex North America Limited at
1-800-346-7539.
Figure 1
OPTIONAL REMOTE CONTROL USAgE
Plug the stove into the outlet located on the side of the
1.
receiver.
Plug the receiver into the wall outlet.
2.
Install a 9 volt battery into the remote control.
3.
Turn the stove’s On/Off switch to the On position prior to
4.
using the remote control.
The remote control works up to 50 feet away.
5.
Push the On button to turn the stove On. Push the Off
6.
button to turn the stove off.
!
NOTE:
To prevent the risk of fire, the stove plug must be
inserted fully into the receiver.
!
NOTE:
The remote control and receiver use one of 243
independent frequencies. When replacing the remote control
or the receiver they must be replaced as a set to ensure
proper operation. The frequency of the remote is located on
the back of the remote on a label. (Figure 2)
!
NOTE: The
fireplace On/Off switch must be in the ON
position prior to using the Remote Control.
!
NOTE:
On/Off Remote Control may be used to control
most other electrical devices including T.V.’s, stereos and
lamps.
CAUTION:
For indoor use in dry areas only
CAUTION:
For use on 120 VAC electrical devices with
15 amp resistive load or 1/3 HP inductive load.
OPEN
Figure 2
