8
www.dimplex.com
Assembly
Figure 4
1.
Carefully unpack all of the
components from the box.
(Figure 4)
2.
Remove top cover by turning
the retaining tabs on both
ends of the water reservoir.
(Figure 5)
3.
Install the light bulbs by
aligning the pins on the bulbs
and the fixture and pressing
down until they are fully
inserted. (Figure 6)
4. Install the transducer so that
it is sitting level in the circular
holding area in the reservoir.
5.
Orient transducer wire so that
it does not sit directly above
the emitter and the wire
passes through the slot in the
side of the tank. (Figure 5)
6.
Reinstall the top cover and
ensure both retaining tabs
have been turned so that they
are pointing inwards.
7.
Fill and install the Refill
Container.
!
NOTE:
Normal tap water can
be used in the Optimyst
®
as long
as the tap water is not considered
to be hard water. In the event
your tap water is hard, you may
use softened water or distilled
water with 1/8 tsp of salt (0.5
mL) added to the water reservoir.
(The addition of additional salt
should only be used when you
notice that the unit is not produc
-
ing mist as expected.)
!
NOTE:
During initial
installation, the Refill Container
Transducer
Rock
Media
Removable Refill
Container
Light Bulbs
Remote
Control
Curved Tray
Housing
Media
Tray
Logset
