Dimas WS 400 Series, Руководство оператора

Страница: 12 / 74

10 - English
Operator’s Manual WS 463
Assembling/Installing
equipment
Wall mounting
There are two types of wall mounting available for the
DIMAS WS 400 series. One, the standard wall mounting,
which is supplied on delivery, and secondly the universal
swivel wall mounting.
CAUTION
The DIMAS WS 400 series may only be used
with the two wall mountings described above.
Older Dimas wall mountings are similar to the
new standard wall mounting, but have a longer
base. This mounting must not be used with the
WS 400 series as there is a risk that the arm
catches on the base of the mounting.
Use the universal wall mounting when cutting doors,
cutting flush, cutting at angles and stair cutting as well as
groove cutting. If you only require an everyday straight cut
you use the fixed mounting.
Fit the universal wall mounting for the required cutting
method (See the separate manual).
Fit the standard wall mounting as set out below:
1. Mark off the cutting line and mark off the expander
bolts holes 164 mm (6.5") from the cutting line.
2. Drill 15 mm holes for the M12 expander bolts.
3. Hang the wall mountings loosely from the expander
bolts, using M6S 12 x 70 or similar.
4. Place the rail in the wall mountings and tighten the
compression washers.
5. Check that the rail sits correctly in the slots in the wall
mountings.
6. Adjust the distance between the cutting line and the
wall mounting. The distance between the edge and the
inner face of the saw cut should be 89 mm (3.5").
Tighten the expander bolts.
CAUTION
Only use the connectors supplied when
purchasing the saw as older connectors are
not designed for the WS 400 series.
165 mm
6,5"
89 mm
(3.5")