2. Install the front-end cap and PC cover.
3. Slot the place where the profile need to be
installed. The length of the groove is determined by
subtracting 8 mm from the actual length of the
product. It is recommended that the width be 19 mm
and the depth be greater than 6 mm. Also reserve a
DC power cord.
4. Apply glass glue on both sides of the groove
6. After the glue is cured, the profile is firmly adhered.
The installation is complete.
5. Connect the profile cable to the reserved DC
power cable, pay attention to the positive and
negative poles. Put the profile into the slot and press
it.
1. Attach strip light at the center of the inner
bottom of aluminum profile.
Installation Guide
（AP2507B）
Trim Recessed
