5
2.0 Transmitter Installation
The transmitter comes pre-installed in the mounting cradle. No adjustments
need to be made to the transmitter or its mounting nut.
It is recommended to install the transmitter/cradle at the location of the
wheel’s valve hole so its location is always known during tire mounting, tire
dismounting, and if the need arises, to scan the transmitter.
2.1 Peel off the adhesive paper from the bottom of the transmitter’s cradle.
The adhesive on the cradle prevents the assembly from rotating around
the wheel barrel.
2.2 Adhere the transmitter’s cradle to the left or right of the wheel’s valve
stem. The transmitter can point inward or outward.
2.3 Insert the band through the lowest slot of the cradle.
2.4 Cut off excess band with tin-snips before tightening the worm-drive clamp.
2.5
Tighten the band’s screw to 40 inch pounds using
a 7mm ratchet or
Phillips-head driver.
2.6 Lock the wheel on the tire changer. Apply lubricant on both tire beads .
Mount the lower tire bead on the rim. Ensure that the tire bead does not
touch the electronic module during mounting.
2.7 Mount the upper tire bead the same way and inflate the tire to standard
cold inflation pressure. Avoid damaging the transmitter’s antenna.
2.8 Apply soap suds or commercial leak detection solution around the wheel’s
valve to check for leaks.
2.9 Dynamically balance the wheel before it is put back on the vehicle.
ADHESIVE
BACKING
FIGURE 4
FIGURE 5
WHEEL’S VALVE