2
1.0 Setting Up the System
1.1 Transmitter Installation
Have a professional tire retailer install the bands with transmitters in the
wheels. See section 2 for details. Each transmitter has a unique ID and
needs to be installed in the same corresponding position as noted in
Figure on page 11.
1.2.4 If your tire cold inflation pressure is 35 psi, you are done. If it is
something besides 35 psi, complete section 1.3.
1.3 Setting the Baseline (Cold Inflation) Pressure
1.3.1 Set the pressure in all tires to the recommended cold inflation
pressure.
1.3.2 Plug in the display using either provided power cord.
1.3.3 Hold down the “R/D” button until
you hear a beep then release.
1.3.4 Press and release the “SET” button.
The display will show “dd” in place
of the pressure readings.
NOTE
:
For hardwired connection, black wire is ground and red is positive.
1.2 Install the Display
1.2.1
Install the supplied antenna to your display unit located at the back of
the unit.
1.2.2 Use the display mount to affix the display unit on the windshield or
dashboard. Do not block the driver’s view. If necessary, adjust the
viewing angle of the display.
1.2.3 Plug the power cord into the display unit and plug the adapter into
auxiliary power supply or hardwire to vehicle electrical system.
FIGURE 1
FIGURE 2
