Digium, Inc.
Page 29
Chapter 2: Card Installation
6.
Plug the T1 or E1 equipment cable into the RJ45 port.
Note:
It is recommended that you use shielded cables.
Software Installation
Digium hardware requires drivers and libraries that are not integrated
with the Linux kernel. Digium hardware is only supported under Linux.
Digium recommends CentOS, Debian, Red Hat, and Ubuntu distributions
of Linux. However, many other distributions are supported by Digium
Technical Support.
Digium’s software, including drivers and application software, may be
obtained from Digium’s download server at:
For an introduction to Asterisk, Digium’s telephony software, including
additional information on its configuration, setup, and features, please
refer to:
http://www.asterisk.org
For the latest information on setting up and configuring DAHDI drivers
for your Digium hardware product, please refer to the latest release of this
manual which is available from the product-specific documentation
Caution.
This unit must be connected to the Telecommunications
Network in your country using an approved line cord (e.g. for
Australia use only line cords complying with ACA Technical
Standard TS008).
Caution.
This unit must be connected only to the appropriate
Telecommunications Network port (as approved for use in your
specific country).
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
