Digium, Inc.
Page 51
Chapter 3: Configuration
Testing Your Configuration
1.
Load DAHDI drivers into the kernel using the
modprobe
utility. The
appropriate driver for the TE120 Series cards is
wcte12xp
. Users in all
countries except Australia should use the following modprobe
command:
# modprobe wcte12xp
# dahdi_cfg -vv
# dmesg
Figure 8: Example dmesg Output
Note: Output as shown above may vary depending on the TE120
Series card you use.
ACPI: PCI interrupt 0000:01:00.0[A] -> GSI 21 (level, low) -> IRQ
209
PCI Config reg is 02900117
wcte120p: New Reg: fe590000!
Detected REG0: 00000100
Detected REG1: 00007849
Detected REG2: 0000001d
(pre) Reg fc is 50000027
Detected REG0: 0000ffff
(post) Reg fc is 50000024
Detected REG2: 0000ffff
wcte120p: reg is a04c0004
TE120P: FALC version: 00000000
TE120P: Setting up global serial parameters for T1 FALC V1.2
TE120P: Successfully initialized serial bus for card
Found a Wildcard TE: Wildcard TE120P
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299