Digitrax Zephyr Express DCS52, Руководство пользователя

Страница: 18 / 32

© 2022 Digitrax, Inc. www.digitrax.com 18 18
that you are able to program decoders using the program only DCC outputs
while the layout is running on the other set of DCC rail outputs. When you
hooked up your DCS52 to the layout, you use the RAIL A & RAIL B con-
nections to the track. Now we will add the PROG A & PROG B outputs to
set up an isolated programming track.
NOTE: The programming track is powered during programming only and can-
not run locomotives. You will have to manually move your locomotive to the
mainline or running track. Your programming track can be as simple as a spare
piece of track (not connected to the layout), as shown in Figure 4.
7.1.1 Using Quick Decoder Setup:
Be sure that only the locomotive you want to program is on the programming
track if you use Direct, Paged or Physical types of Service Mode CV program-
ming.
1. To enter Quick Decoder Setup, press the
key. Main Menu A will display giving
you a list of menu options. Select 1-Quick
Decoder Setup by pressing the key on
the keypad.
2. This will put you in Quick Decoder Setup.
This uses Service Mode type Direct
Programming on the program track. In
this mode you can change the; 2digit loco-
motive address AD2 or the 4 digit loco-
motive address AD4, and CV29 decoder
configuration settings.
3. Once in the Quick decoder setup menu
you can change AD2 and AD4. You must
decide what address you want to use, for
addresses 0000-0127 you use AD2. For
addresses 0128-9983 you use AD4.
4. Press the key “READ” to read the cur-
rent data from your decoder on the pro-
gramming track. This read step isn’t
required but is useful in confirming current
decoder settings, and that the decoder and
program track are working.
5. To set AD2 press the key on the key-
pad to highlight the AD2 line. Press the
key “DATA” so the numeric keys now
setup AD2. Use the numeric keys to enter
the address you want to use, press the
key “WRITE” to now write the AD2
address to the decoder. To make changes
Quick Decoder Setup
0- Last Menu
1- AD2 ShortAdr
2- AD4 Long Adr
3- CV29 Value
9-
4- NDOT Rev
5- 28 not 14 Step
6- Analog
7- Speed Table
8- Use AD4
=
Pd Mode
==
=
OFF
ON
ON
OFF
ON
Trk USB Ln
READ WRITE DATA
MAIN Menu A:
0- Last Menu
1- Quick Decoder Setup
2- CV Programmer
3- Utility Tasks
EXIT
USB Ln Trk