Digitimer Ltd – D360R-4 Operator’s Manual
Version 1.0
25
Digitimer Ltd.
Copyright ©2021
4.
Click Finish to complete the software installation and move onto the hardware connections.
Hardware Installation
Do NOT proceed with hardware installation until the Windows Client Software has been
installed on the host PC.
1.
After ensuring the D360R-4 is set to the correct local voltage and the correct mains fuses are
installed and the power switch is set to Off, connect the mains lead (power cord) between a
power socket and the mains inlet socket on the D360R-4.
2.
Connect the signal output cable between the “D” connector on the rear of the D360R-4 and
the signal inputs on the data acquisition system or signal conditioner (e.g. our D400 50/60Hz
Mains Noise Eliminator).
3.
Connect the supplied USB cable between the D360R-4 and a spare USB port on the host
computer
4.
Moving to the front of the amplifier, connect the D360R-4 H/S headstage via the 2m long
headstage connection cable. Push connect the cable between the headstage and the main
amplifier, taking care to ensure the black arrow-marked key-ways are aligned with the white
polarising mark on the sockets (see below). On the headstage the socket and white
polarising mark is rotated 180 degrees, so it may be easier to invert the headstage during
cable connection.
