DigiTech Mistral3, Руководство пользователя

Страница: 18 / 30

Press to exit and confirm the programming.
By using the “Main clock”, the chronometer calculates and displays the
residual time to the programmed time.
Please not that since it is not necessary to start the CD, you can edit its
setting at any time, without loosing your data .
At any change of the programming, the
recalculates the
new expiry and displays on the screen the residual time to the programmed
time.
I
WARNING: since the Alarm mode is connected to the main
clock, any change to it will cause a change to the residual time
from the programmed time.
Beep mode ( b x )
This is the simplest of the operating modes.
After selecting the Beep mode, any preset time is reset.
If you exit programming by pressing
, the chronometer displays 0.00
and switches to “ready to start” ( STOP . on)
If you operate the key or the external remote control, the
count will start.
Seconds are counted up one by one (the seconds timer is automatically
started but you can disable it).
Operate the external remote control or press the
key once
more, to freeze the time on the display with the hundredths and to
immediately reset the counter:
A lap counter in the “
Join | Lap ” area of the display in incremented at each
split.
Time is automatically “unfrozen” after the pre-set time has elapsed or if you
press the key.
Press for approximately 2 seconds to reset default conditions
(seconds timer “ready to start” and lap counter to zero) è necessario tenere
premuto per circa 2 secondi il.
The countdowns english
14