DigiTech Mistral3, Руководство пользователя

Страница: 17 / 30

After the zero, counting up continues (without the “minus” sign), showing a
delay compared to the time set.
Timer split
After the A countdown has started, by pressing or using the
external remote control, the countdown is split. The time including
hundredths is frozen on the display, preceded by “-” if it has been split
before reaching zero, or without sign if after the zero:
F
It is always a good rule to split the chronometer as you pass the
finishing line: this will allow you to compare the time you have
taken with the one taken by the chronometrist, in order to avoid
any error in the transcription of the time of your schedule.
The time freezing is automatically removed after the pre-set time has
elapsed or by pressing the key.
Timer reset
When a Timer is started, usually it is not necessary to stop it.
If the Timer has started by mistake, all you need to do it press the
key. After about 2 seconds the timer is reset to the
previously set time and it sets to the “ready to start” mode.
Reprogramming the duration
You can change the timer duration at any moment by pressing the
key.
If you change the duration, when you exit programming you can obtain two
results, based on the condition of the timer before its change:
®
timer stopped ( STOP ): the new setting is shown on the display and the
timer is ready to start,
®
timer running ( RUN ): using the time of the previous start and the new
duration, the new expiry is calculated again and the residual time is
shown on the display.
Alarm mode ( A x )
If you select the Alarm ( A ) type, the time to be set is not a “duration”, but a
time of the day.
The programming mode of the time of the day when the countdown should
elapse is the same as the timer mode.
english The countdowns
13