DigiTech GNX3, Руководство пользователя

Страница: 60 / 84

Recording the Mic Input
The GNX3 is equipped with a mic input that is used for recording vocals or acoustic instruments. In
order to get the best level recorded, it is necessary to setup the mic input gain properly. To setup the
input gain for the mic, follow these steps:
1. Connect a microphone to the MIC INPUT on the rear panel.
2. Begin singing or playing the instrument into the mic.
3.Turn the
MIC LEVEL control on the rear panel clockwise for more gain and counter-clockwise for
less gain until the CLIP LED next to the GNX3’s main display only flashes occasionally. If it is flashing
often or solid red, turn down the gain. If the CLIP LED doesn’t flash, turn up the gain until it does flash
occasionally.
Once the mic input gain is set properly, you need to select one of the mic input configurations in the
recorder Setup utility. To select a mic input configuration, follow these steps:
1. Press the SETUP button once on the recorder panel. The display reads
recinput
and then begins
flashing the selected input configuration.
2. Use the DATA WHEEL to select one of the mic input configurations. See page 39 for the GNX3’s
recorder input configurations and their descriptions.
3.When finished, press EXIT .
Now you can begin recording the mic input like any other track using the steps outlined in the Recording
a Track section.
Recorder Output Configuration
The GNX3’s digital and analog outputs can be configured in a number ways to best utilize the recorder
and guitar processor both independently and simultaneously. If you plan on using the guitar processing
along with playback of the recorder, there are several options for routing the guitar processor and the
recorder signals independently of each other. This works well when either running directly into a mixer
or using a guitar amp and mixer together. To set the Output configuration, follow these steps.
1. Press the UTILITY button.
2. Press the MODE or DRUMS button until the display reads
anlg out
. The default configuration
from the factory is
Stereo
.
3. Use the DATA WHEEL to select
mono
,
stereo
,
g>l r>r
,
mono gtr
, or
ster gtr
.
Stereo
and
Mono
output configurations have both recorder and guitar processor mixed together at both the
analog and digital outputs while
g>l r>r
configures the left and right analog outputs as a mono guitar
processor out and a mono recorder out respectively.
Mono gtr
and
ster gtr
configurations send
guitar processor signal only out the GNX3’s analog outputs.
The S/PDIF digital output can also be configured in a variety of ways that best suit your recording or
performance situation. To setup the S/PDIF options, follow these steps:
1. Press the
UTILITY button.
2. Press either the MODE or DRUMS button until the display reads
DIGI OUT
. The default
configuration from the factory is
GTR+REC
. This configuration sends both guitar processor and
recorder output to the S/PDIF output.
3. Use the DATA WHEEL to select
RECORDER
if only the recorder output is what you want sent to the
54
Recorder