DigitaLinx EDU-KIT-001, Руководство по установке

Страница: 8 / 24

1. Verify all components included with the EDU-KIT-001 are present before
installation.
2. Turn off power and disconnect the audio/video equipment by following the
manufacturer’s instructions.
3. Attach the included rubber feet or mounting ears to the receiver.
4. Connect an HDMI cable between the HDMI output of the Receiver and the HDMI
input of the display. The HDMI cable should not exceed 5 meters (16 feet).
5. Connect a microphone to the microphone input connector.
a. “+” connects to positive
b. “–’ connects to negative
c. “
╧
” connects to ground.
6. Adjust the microphone input mode selector based on the type of microphone to
be connected to the Receiver.
a. MIC – 48dB gain
b. LINE – 4dB gain
7. Connect the speakers to be used in accordance with the Speaker Wiring
Configurations. If an external audio amplifier is to be used with the system, connect
the unbalanced analog audio output of the Receiver to the input of the amplifier.
8. If the display is to be controlled via IR, plug the IR emitter to the IR Out port of
the Receiver and mount the IR emitter bud to the IR receiver port of the display.
9. If the display is to be controlled via RS232, plug the 3-pole terminal plug end of
the included RS232 cable into the RS232 port on the Receiver and the DE9 end to
the display.
10. Connect a USB cable between the display’s interactive white board USB port and
the USB port labeled “From Touchscreen” on the rear of the Receiver.
11. Connect a Category 6A or greater cable between the Network TCP/IP port and the
facility’s network.
12. Connect a Category 6A or greater cable between the Input port of the Receiver and
the Output port of the Transmitter. This cable cannot exceed 30 meters (98 feet).
13. Connect a Category 6A or greater cable between the Power and RS232 port on the
Transmitter and the Power and RS232 port on the Control Panel.
14. Connect the included USB cable between the TO PC port on the front of the
Transmitter and the PC to receive the commands from the interactive white board.
15. Plug the power supply into the power input port on the Receiver.
16. Power on the Receiver by plugging the power cable into the power supply.
17. Power on all audio/video devices.
Installation Instructions