1. Verify all components included with the DL-RMKTC1H1V-W are present before installation.
2. Turn off power and disconnect the audio/video equipment by following the manufacturer’s
instructions.
3. Attach the included rubber feet or mounting ears to the receiver.
4. Connect an HDMI cable between the HDMI output of the Receiver and the HDMI input of
the display. The HDMI cable should not exceed 5 meters (16 feet).
5. Connect a microphone to the microphone input connector.
6. Adjust the microphone input mode selector based on the type of microphone to be
connected to the Receiver.
a. MIC – 48dB gain
b. LINE – 4dB gain
7. Connect the speakers to be used in accordance with the Speaker Wiring Configurations. If
an external audio amplifier is to be used with the system, connect the unbalanced analog
audio output of the Receiver to the input of the amplifier.
8. If the display is to be controlled via IR, plug the IR emitter to the IR Out port of the Receiver
and mount the IR emitter bud to the IR receiver port of the display.
9. If the display is to be controlled via RS232, plug the 3-pole terminal plug end of the
included RS232 cable into the RS232 port on the Receiver and the DE9 end to the display.
10. Connect a USB cable between the displays interactive white board USB port and the USB
port labeled “From Touchscreen” on the rear of the Receiver.
11. Connect a Category 6 F/UTP or greater cable between the Network TCP/IP port and the
facility’s network.
12. Connect a Category 6 F/UTP or greater cable between the Input port of the Receiver and
the Output port of the Transmitter. This cable cannot exceed 30 meters (98 feet).
13. Connect a Category 6 F/UTP or greater cable between the Power and RS232 port on the
Transmitter and the Power and RS232 port on the Control Panel.
14. Connect the included USB cable between the TO PC port on the front of the Transmitter
and the PC to receive the commands from the interactive white board.
15. Plug the power supply into the power input port on the Receiver.
16. Power on the Receiver by plugging the power cable into the power supply.
17. Power on all audio/video devices.
Installation Instructions
