Digital Systems DS512, Руководство пользователя

Страница: 20 / 52

OPERATION AS STAND-ALONE
VEHICLE SECURITY SYSTEM
MODE 3 (SILENT ALARM) OR MODE 4 (FULL ALARM)
CHAPTER 1
ARMING THE VSS AND LOCKING CENTRAL DOOR LOCKING SYSTEM
ARMING WITH INTERIOR MOTION DETECTOR AND ADDITIONAL SENSOR DISABLED
DISARMING THE VSS AND UNLOCKING THE CENTRAL DOOR LOCKING SYSTEM
TRUNK RELEASE BUTTON LOGIC
DOOR OPEN WARNING WHEN ARMING - DOOR AJAR
ALARMING / DISARMING THE VSS DURING THE ALARM
Press the LOCK button on the remote transmitter - direction indicators blink
and single siren chirp (optional) confirms the VSS is being armed and the central
door locking system is locked. The LED will light constantly and after 10 seconds
it will start to blink slowly.
If the VSS is armed with any person or animal is in the vehicle, their movement
will trigger the alarm. To avoid such situation, the system can be armed without
activating interior motion detector and additional sensors. To do so, before
arming the system - press and hold the PA button until siren chirp. The LED will
blink once per 2 seconds.
Leave the vehicle, close all doors and press the remote transmitter LOCK
button - two siren chirps confirms the system is armed and interior motion
detector and additional sensor are disabled. Direction indicators blink confirms
the vehicle security system is armed and the central door locking system
is closed. The LED will light constantly and after 10 seconds it will start to blink
slowly. Turning the ignition ON enables the interior protection with next arming
of the VSS.
Press the remote transmitter UNLOCK button - blink of the direction indicators
and double siren chirp (optional) confirms disarming of VSS and unlocking
central door locking system. The status LED will start blinking until any door
is opened and then will go off.
If the alarm was triggered during the driver's absence, the VSS signalises
it during disarming with three siren chirps.
IMPORTANT!
If after disarming neither doors nor trunk is opened within 30 seconds the
system rearms automatically.
If OEM remote transmitter has a trunk release button press of this button will
open (or allow to open) the trunk / boot and turn off the protection of trunk
switch, interior motion detector, additional sensors, and the sliding doors (in Van
vehicles - rear left and rear right).
That state is confirmed by fast blinking of the LED. Depending on the vehicle,
closing the boot / van doors or press of the LOCK button on the OEM remote
brings the security system again into armed state, signalled by slow LED pulses.
IMPORTANT!
This feature is car dependent.
If any doors, bonnet or trunk is not closed during arming, the VSS signalises it with
three siren chirps. The system will be armed, but the opened door / bonnet / trunk
will not be monitored (alarm will not be triggered after violating this input).
If the VSS is armed and any door, trunk or bonnet switch, additional sensor,
ultrasonic motion detector or ignition is violated, the VSS starts a 30-second
alarming cycle - the direction indicator lights starts to blink and electronic siren
starts audible signal and next starts a 30-second alarming cycle the direction
indicator lights starts to blink only, the LED blinks quickly, 2 times faster than
in armed mode. After 30 seconds, the system stops the alarm cycle. Further
triggering of sensors starts another alarm cycle. Every input can cause up to
4 alarm cycles and then it is blocked. During alarm cycle, press of the LOCK
ds512 alarm
20