Using the projector
Digital Projection Ltd. E-Vision Laser 13000 WU Series
Some 3D settings explained
In order to achieve
maximum light output and
a smooth grayscale, whilst
eliminating ghosting, the
following procedure is
recommended:
1.
Set
Dark Time
to a
value appropriate to the
glasses or ZScreen, say
1.3 ms or 1.95 ms.
2.
Adjust
Sync Offset
time
to eliminate ghosting and
achieve a smooth
grayscale.
3.
Repeat steps 1 and 2
until the best result is
obtained.
Dark time
Fully On
Fully Off
Left
Right
Dark
Time
Dark
Time
Dark
Time
Banding can be caused if the image is displayed before each
eye of the 3D switching glasses or ZScreen is not fully open.
Dark Time
allows you to minimize this effect.
Eye swap
LEFT 1
LEFT 2
LEFT 3
RIGHT 1
RIGHT 2
RIGHT 3
Dominance Left
LEFT 1
LEFT 2
LEFT 3
RIGHT 1
RIGHT 2
RIGHT 3
Dominance Right
The outgoing 3D frames are in pairs - the dominant frame
being presented first. You can determine which frame should
be the dominant one.
By convention the default setting is
Left
.
Operating Guide
Rev A June 2019
page 73
Notes
Содержание E-Vision Laser 13000 WU Series
