Digital Monitoring Products 7800 series, Руководство пользователя

Страница: 11 / 28

Introduction Graphic Touchscreen Keypad User Guide 7
Special Keypad Tones
Your keypad contains an internal speaker that alerts you about
events as they occur on your system.
Note:
For burglary alarms, the tone will silence as soon as the first
user code digit key is pressed. If a valid user code is not entered
within 5 seconds or an invalid user code is entered, the burglary
tone begins sounding again.
Below are brief descriptions of the different tones you hear from
the keypad.
Fire alert:
An intermittent sweeping siren that continuously repeats
until the fire alarm is silenced. This is in addition to a separate
siren activated by the alarm panel.
Burglary Alert: A siren tone that continues until the alarm is
silenced. This is in addition to the separate siren output operated
by the alarm panel.
Prewarn : A tone that sounds when you open an entry delay door
on a system that is armed (turned on) reminding you to disarm the
burglary protection.
Your system will silence the tone as soon as the first user code
digit key is pressed. If a valid user code is not entered within 5
seconds or an invalid user code is entered, the prewarn tone begins
sounding again.
Exit:
When fully arming your system to leave, a pulsing tone sounds
during the exit countdown just after arming to remind you to exit
the premise. At ten seconds prior to the end of the countdown, the
rate of pulsing increases.
Monitor (Chime): A tone that sounds each time a door or window is
opened while you are using the Zone Monitor (Chime) option from
the User Menu. See Zone Monitor in the panel user guide.
Trouble:
A steady tone indicating a trouble condition on your
system.
Special Keypad Displays
As you use your system, you may occasionally see a message display
that asks you to enter a user code or describes a condition on the
system. Below are some examples of the displays you may see.
ALARM
A 24-hour zone, such as a fire or panic zone, or an armed burglary
zone is faulted. Keypad will sound an alarm and any other sirens
programmed in your panel by the installer.
ALARM NOT SENT
The alarm signal was aborted and was not sent to the Central
Station because a user code was entered to disarm the system
before the alarm signal was sent to the Central Station. Also, your
system may be pre-programmed at installation to send an Abort
signal to the Central Station.
ALARM CANCELLED
An Alarm signal was sent to the Central Station and was cancelled
by a user who entered their user code to silence the alarm.
ALARM VERIFIED
A valid burglar alarm has occurred and has been manually verified
by the user. The alarm system also transmits a VERIFY message to
the Central Station.
ENTER CODE
The system requires you to enter a personal user code. User codes
can be used for turning your system on (arming), turning your
system off (disarming), and other system options.
As you enter your user code, the display shows an asterisk (*) in
place of each digit pressed. This prevents others from seeing your
user code on the display as you enter it.