Digital Equipment VXT 2000 Model VX225, Информация по установке

Страница: 27 / 42

Installing Optional Memory
Discharge the electrostatic charge.
1. After you open the rear cover, touch the terminal’s metal chassis, to
equalize any static charge.
2. Remove the memory modules from their antistatic bags.
Install the memory modules.
Refer to the following figure.
1. Find the slot labeled J1 at the right edge of the system logic board.
2. Place the first memory module into slot J1 at a 45-degree angle. The notch
on the bottom corner of the memory module should fit into the bottom of
the slot for the connector.
3. While pushing in on the memory module, move the memory module into a
standup position. Both sides of the module lock into the metal connector
clips. Make sure the plastic tabs go into the holes on the memory module.
Also make sure the metal connector clips return to their original position.
L J - 0 2 1 6 9 - T I 0
45
J1
J2
J3
VX227 model: If there is an image accelerator board installed to the left
of slot J3, temporarily remove the image accelerator board before trying to
install a memory module in slot J3.
VXT 2000 Models VX225 and VX227 21