January 1994
The information in this document is subject to change without notice and should not
be construed as a commitment by Digital Equipment Corporation.
Restricted Rights: Use, duplication, or disclosure by the U.S. Government is subject
to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in Technical Data
and Computer Software clause at DFARS 252.227-7013.
FCC ID: A09-VRC21
Note:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. Any changes or modifications made to this equipment may
void the user’s authority to operate this equipment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio and television reception; however, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The video input to this device is through the 5 BNC connectors located at the rear of
the device. The optional 15-pin D sub-miniature connector at the rear of the device
is not a supported option and shall not be connected to any cable at the same time
as the 5 BNC connectors are connected to cables, as this will cause video quality
degradation, and may cause increased levels of radio frequency interference.
There are no user serviceable parts inside. Do not attempt to modify
this equipment. If modified, your authority to operate this equipment
might be voided by the FCC.
Canadian Department of Communications (DOC) Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the radio interference regulations of the Canadian
Department of Communications.
DEC and the DIGITAL logo are trademarks of Digital Equipment Corporation. The
Energy Star emblem does not represent EPA endorsement of any product or service.
Copyright © Digital Equipment Corporation 1994.
All rights reserved.
Printed in Japan.
This document was prepared using VAX DOCUMENT Version 2.1.
