To put it another way:
CompacTape
CompacTape II
CompacTape III
Read
Read
Read/Write
Note
The tape drive can read cartridges recorded by TK-series tape drives, as
well as by TZ30 and TZK50 tape drives. Tapes written on a TF-series
drive can be read only on that drive.
You can identify the type of cartridge by its label.
TF-Series Tape Drive Controls and Indicators
The tape drive has two primary controls: the cartridge insert/release handle
(subsequently referred to as the handle) and the Unload button.
• You use the handle to insert or remove cartridges and lock them in position:
Pull the handle open to insert or remove a cartridge. Push the handle closed
to lock a cartridge in position and load the tape.
• You use the Unload button to rewind and unload the tape. Rewinding and
unloading can also be controlled by software. Refer to your system software
manuals for appropriate commands.
A bus node ID plug on the drive’s front panel identifies the bus node number (unit
number) of the device to your system.
Note
Refer to Appendix B for information on setting or examining parameters
for DSSI devices.
The drive has four indicator lights that show its status.
• Write Protected (Orange): A steady light means the cartridge is write-
protected.
• Tape in Use (Yellow): A steady light means the tape is loaded. A blinking
light means the tape is in motion.
Operating the System Options 3–11
