Digital Equipment Digital EtherWORKS 3 Turbo, Информация пользователя

Страница: 26 / 66

Resolving BUS Conflicts on ISA and EISA
Systems
Once you have installed the
Turbo
board, you are ready to turn on the
system and begin the setup and software device driver installation.
The
Turbo board is shipped with the following pre-programmed
factory-default settings:
• Memory address: D0000h - D07FFh (2-KB mode)
• I/O Base address: 300h
• Interrupt value: 5
If a setting conflicts with a resource in the system, the system may
not operate correctly. If this occurs, you may need to use jumpers to
cover either the W1 and/or W2 posts to override the factory default
settings. (This is called a "hardstrap override.")
Table 2–2 lists the available jumper selections. Figure 2–6 shows the
factory-default (Out position) default jumper settings for W1 and
W2 on the Turbo , Turbo TP , and Turbo PLUS boards.
Note
If a hardstrap override does not resolve the system conflict,
contact your local Digital Service Representative.
2–10