Vodafone Business Surveillance – IP470 Installation User Guide
C1 – Public
Page 35
11.
Appendix C
–
Vehicle Installation
The HD-IP470 unit is designed for in-vehicle deployment.
Dimensions and fixings for in-vehicle installation
Ensure that you have adequate space to install the HD-IP470 mounting plate and unit with access to the
camera inputs, antenna connections and removable storage device on the front plate. The 8~35V battery
input power connection is located on the side of the unit and this should be factored in when siting the
unit in a vehicle.
To install the mounting plate, remove and retain the bolts holding the rubber feet to the unit. Remove the
rubber feet. Install the mounting plate and secure it by replacing the bolts though into the base of the
encoder.
Connecting the HD-IP470 to a vehicle battery
The HD-IP470 can be powered directly from a vehicle battery – either a 12V or 24V
power source.
When installing in a vehicle, the following connections must be made to the power
input connectors on the rear of the unit:
Connect negative to the contact marked ‘GND‘ on the DC input connector.
Connect positive to the contact marked ‘V+’ on the DC Input connector.
Connect ignition line to the contact marked ‘IGN’ on the DC Input connector.
Note: the unit will power up 10 seconds after the IGN switch is connected and will
switch off 10 seconds after the IGN switch is disconnected.