Vodafone Business Surveillance – IP470 Installation User Guide
C1 – Public
Page 4
1.
Introduction
This document will help set up and configure HD-IP470, allowing it to record
and be viewable remotely from a Vodafone Business Surveillance Server.
Before proceeding with the installation and setup of your HD-IP470 unit, please ensure that you check the
package contents listed below, refer to the installation notes on the next page and consult the Quick Start
Guide that was supplied with your unit for step-by-step instructions on preparing hardware and software
components.
To operate this device, you will need to set up, or have access to, the following architecture:
To proceed you must have access to the Vodafone Business Surveillance Server, with an account created for
the encoder to use.
1.10
What is in the box?
EdgeVis encoder
EdgeVis HD-IP470
Accessories
AC/DC 12V power supply, mains power lead, DC power block, two cellular
antennae, two Wi-Fi antennae, mounting plate
Printed materials
Quick Start Guide
1.11
Safety Notes
The HD-IP470 can operate in temperatures from -20˚C to +50˚C (+55˚C without POE) whilst powered
from 12V – 35V DC.
All deployments of an HD-IP470 encoder unit should ensure that the device is not
mounted:
Within explosive zones
Within 0.5m of a powered transmitter and/or receiver antenna
Within the engine bay/compartment of a vehicle
Within 1m of a vehicle fuel fill point (direct line of sight)
Vodafone Business
Surveillance Encoders
Vodafone Business
Surveillance Clients
Vodafone Business
Surveillance Server
send video to
sends video to
SSD
