Digital-Ally DTM-600, Руководство пользователя

Страница: 50 / 98

860-00324-00 Rev B 50
external device is connected or external devices
do not need O&M management.
⚫
Bluetooth Mode: This option is displayed when
the face recognition terminal is used with a smart
lock via Bluetooth.
⚫
Wiegand IC Card Mode: Select this option when
the face recognition terminal connects to a card
reader through RS232.
Set this parameter based on actual scenes.
NOTE! For RS485 and RS232 serial ports, Port Mode cannot be set to a gate mode at the same time.
Enable Security
Module The configuration is not supported.
/
RS485 Address
The configuration is not supported.
/
Baud Rate
The configuration is not supported. Use the default value.
Data Bits/ Stop
Bits/ Parity/
Flow Control
Keep the default values as follows:
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: None
NOTE! The parameters cannot be set when Port Mode is set to IC Card Mode .
Enable Trans-
Channel
It is used for internal debugging. Ignore it.
(2)
Configure serial port information based on actual scene configuration.
(3) Click Save to complete the serial port configuration.
(2) Wiegand Interface
When the face recognition terminal connects to an IC card reader, Wiegand interface information needs to be
configured. Perform the following operations to complete the configuration:
(1)
Choose Setup > Common > Ports & Devices and click the Wiegand Interface tab.
NOTE!
⚫
Some devices support the input through only one or zero Wiegand interfaces and the configuration window for
the Wiegand input interface is different for the devices.
⚫
Some devices do not support the output through the Wiegand interface. In this case, the configuration window
for the Wiegand output interface will not be displayed.
⚫
The Wiegand interface configuration window is unavailable to ET-B31H-M@B with a built-in IC card reader.
Figure7-23 Wiegand Interface Configuration Window
(2) Configure Wiegand interface information by referring to the table below.