Page 6
Digit-KD instruction manual
ENGLISH
MAINT
OK
As soon as the control panel is powered up, it switches au-
tomatically into Maintenance status. On the keypad the
“TEST” LED will flash slowly and, if no zone is triggered,
on the display the message shown will appear:
5.0. MAINTENANCE STATUS
In the case that an alarm has been triggered in one or more
zones, the zone will be indicated on the display starting
from the highest priority. At equal priority level, the first zone
violated will be indicated.
MAINT
fire wire
Fire zone in alarm
Zones 3 and 4 in alarm
MAINT
OK
1 2
3 4
To verify if there are others zones triggered,
press more times the button "FORWARD".
On the display will be visualized the menu with
the list of all zones, plus Bat (low battery), Tmp
(tamper) and Firendio (fire).
Next to each triggered zone a dot lit will appear
(see example on the right).
MAINT
OK
6.0. DISARMING
With the control panel in Maintenance, armed or Test-
Control status, to disarm the control panel proceed as
follows:
Digit one of any of the memorized
codes (example 1, 2, 3). On the
display 3 asterisks will appear.
***
OFF
OK
If while the control panel is armed alarms
have been triggered, when you disarm, on
the display the message related to the last
zone that has been triggered flashes
slowly (see example on the right).
In the above example, the
"zone 2" has triggered an alarm
OFF
Z.2 filo
To verify if other alarms have been
triggered, press more times the button
"FORWARD". On the display will be vis-
ualized the menu with the list of all zones,
plus Bat (low battery), Tmp (tamper) and
Firendio (fire). Next to each triggered
zone a dot will appear that flashes slowly
(see example on the right).
OFF
1 2
3 4
In the above example, the
"zone 3" has triggered an alarm
Press the button to confirm. The control
panel emits 2 beeps (only from control
panel armed to disarmed). On the display
“OFF” appears. The control panel is disarmed.
