DG-VG2300N User
Manual
27
The following table describes the parameters of this page:
Field
Description
WAN physical type: Ethernet
WAN (Port-LAN1)
When this option is selected the unit will auto reboot.
Default Route Selection
You can select Auto or Specified.
VPI
The virtual path between two points in an ATM network, ranging from 0
to 255.
VCI
The virtual channel between two points in an ATM network, ranging from
32 to 65535 (1 to 31 are reserved for known protocols)
Encapsulation
You can choose LLC and VC-Mux.
Channel Mode
You can choose PPPoE, PPPoA and 1483 Routed.
Enable NAPT
Select it to enable Network Address Port Translation (NAPT) function. If
you do not select it and you want to access the Internet normally, you
must add a route on the uplink equipment. Otherwise, the access to the
Internet fails. Normally, it is enabled.
Enable IGMP
You can enable or disable Internet Group Management Protocol (IGMP)
function.
PPP Settings
User Name
Enter the correct user name for PPP dial-up, which is provided by your
ISP.
Password
Enter the correct password for PPP dial-up, which is provided by your
ISP.
Type
You can choose Continuous, Connect on Demand, or Manual.
Idle Time (min)
If set the type to Connect on Demand, you need to enter the idle timeout
time. Within the preset minutes, if the router does not detect the flow of
the user continuously, the router automatically disconnects the PPPoE
connection.
WAN IP Settings
Type
You can choose Fixed IP or DHCP.
If selected Fixed IP, you should enter the local IP address,
remote IP address and subnet mask.
