Digimerge DGR204, Инструкция по установке и эксплуатации

Страница: 35 / 80

35
OFF: Disables AUDIO recording.
NOTE: Audio function can only be activated in the following refresh rate in NTSC(PAL): 10(8.3),
6(5), 2.7(2.7), 1.2(1.4), 0.61(0.76), 0.35(0.44) frames/sec
ALM TYPE:
This option allows users to set a type of alarm input corresponding to the sensor signal in use.
NO: Normally Open. This is to be used with the type of alarm sensor whose contact remains
open in normal conditions and closes in case of activation.
NC: Normally Closed. This is to be used with the type of alarm sensor whose contact remains
closed in normal conditions and opens in case of activation.
ALM DURATION:
This option allows users to set alarms for a certain duration. You can select one of the six following
options: 0 SEC, 30SEC, 1 MIN, 5 MIN, 10 MIN, and NON-STOP.
Duration
Set ting
Alarm
activated
Alarm
deactivated
Reset
Alarm recording
Non-Stop
Alarm
activated
Alarm
deactivated
Duration
Alarm recording
Duration
NOTE: Recording may be interrupted at the time of Alarm-in or Alarm-out.
LIVE images may be interrupted at the time of Alarm-out.
PRE- ALARM:
This option determines whether images that occurred prior to an alarm prior to an alarm activation will
be recorded. When an alarm is triggered the device will record the image prior to the alarm for 5
seconds. (
10 frames/sec
)
ON: Enables this function.
OFF: Disables this function.
NOTE: If the device is already in the recording mode before an alarm occurs, the pre-alarm
recording would not take effect.
MOTION SETTING:
The video motion detection function is convenient for the people without alarm trigger input, but also
can used with alarm trigger input at the same time. If this function is enabled, any object movement