Touch RFID
Latch Mechanism
Assigned Use Functionality
Product Guide
3
Programming Instructions
Add Manager Credentials
Manager credentials can be programmed to the locks at any time.
Go to a lock requiring additional
manager credentials.
Touch and hold
`
for 5
seconds (a two-tone beep will
be heard after 5 seconds) then
release.
The LED will flash and the
Reader will turn on.
Insert the Programming Key.
A two-tone beep will be heard.
Insert each additional Manager
Key or present each Manager
RFID one at a time.
A two-tone beep will be heard
for each manager credentials
programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED and Reader will
turn off.
Repeat above steps for each
lock or follow instructions to
Express Register Manager
Credentials to quickly program
the same manager credentials
to operate multiple locks.
Replace Programming Key or Manager Credentials
The locks must be reprogrammed to prevent the lost/stolen Programming Key or manager credentials from operating a lock.
To replace the Programming Key:
Note the order or serial number (found on the lock’s rear unit).
Contact Digilock Support to purchase a replacement
Programming Key.
To replace Manager Credentials:
Collect all remaining and replacement manager credentials.
Go to any lock operated by the lost/stolen manager credentials.
Touch and hold
`
for 5 seconds (a two-tone beep will be heard
after 5 seconds) then release.
The LED will flash and the Reader will turn on.
Insert the Programming Key.
A two-tone beep will be heard.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED and
Reader will turn off. All previously programmed manager
credentials will be erased.
Follow instructions to Add Manager Credentials to program the
remaining and replacement manager credentials to the locks.
1
2
3
4
1
1a
2
2a
1b
2b
