Arty Z7 Reference Manual
Transfer Multisort Elektronik / tme.eu
3
Features
•
ZYNQ Processor
o
650MHz dual-core Cortex-A9 processor
o
DDR3 memory controller with 8 DMA channels and 4 High Performance
AXI3 Slave ports
o
High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
o
Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
o
Programmable from JTAG, Quad-SPI flash, and microSD card
o
Programmable logic equivalent to Artix-7 FPGA
•
Memory
o
512MB DDR3 with 16-bit bus @ 1050Mbps
o
16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-
48/64™ compatible identifier
o
microSD slot
•
Power
o
Powered from USB or any 7V-15V external power source
•
USB and Ethernet
o
Gigabit Ethernet PHY
o
USB-JTAG Programming circuitry
o
USB-UART bridge
o
USB OTG PHY (supports host only)
•
Audio and Video
o
HDMI sink port (input)
o
HDMI source port (output)
o
PWM driven mono audio output with 3.5mm jack
•
Switches, Push-buttons, and LEDs
o
4 push-buttons
o
2 slide switches
o
4 LEDs
o
2 RGB LEDs
•
Expansion Connectors
o
Two Pmod ports
▪
16 Total FPGA I/O
o
Arduino/chipKIT Shield connector
▪
Up to 49 Total FPGA I/O (see table below)
▪
6 Single-ended 0-3.3V Analog inputs to XADC
▪
4 Differential 0-1.0V Analog inputs to XADC
