Delete Races:
Select the race (as in Fig. 21), press and hold [
STOP/RESET
] for 1 second, the display
will show ’ DELETE ? ’, keep holding the key for another 2 seconds, the display will show
‘ DELETED ’ (Fig. 24) At this point the selected race is completely erased. If
[
STOP/RESET
]
is continuously held down, ‘ DELETE ALL ? ’ will be displayed. If
[
STOP/RESET
] is still held down for 2 more seconds, ‘ ALL DELETED ’ will be displayed.
At this point all races in the memory are completely erased (Fig. 25).
Approximately 1 minute is required for the deleting 8000 memories.
**: When selecting races to delete, always note the date information of the race
since the timer will rearrange the sequence number when a race(s) has been
deleted.
Fig. 24 Fig. 25
Loading of Paper:
1. Use thermal paper roll size: Width 37mm x Diameter 30mm max.
2. Pull out the paper cover by pressing both side of the cover slightly, as shown in Fig. 26.
3. To ensure smooth insertion, cut the corner of the thermal paper as shown in Fig 27.
4. Switch on the printer by sliding up the ‘ PRINT ON
/
OFF ’ switch.
5. Insert the end portion of the paper into the paper insertion slot, as shown in Fig. 28.
6. Press the ‘ PAPER FEED SWITCH ’(Fig. 29) until the end of paper is about 1 cm out
from the paper cutter.
7. Replace the paper cover to its original position.
Fig. 27
Fig. 26
Fig.29
Printer ON/OFF switch
Paper Feed switch
Fig. 28
8
**: Do not pull paper out from the printer, this will cause damage to the printer. For
replacing the paper roll before it is used up, tear the paper off and press the
