Digger Specialities Turning Point, Инструкция по установке и эксплуатации

Страница: 7 / 20

TM
TM TM
TM TM TM
7
Turning Point Gates
Gate Installation Instructions
- 4 -
7. Place the nylon “C” washer onto the top pin
of the gate. And then place the top hinge
onto the pin. The top hinge bracket should
touch the nylon “C” washer but allow the
washer to rotate. Place the top hinge against
the mounting surface. (You may need to
adjust your gate support to achieve this.)
Vertically level the gate measuring along
the pivot tube of the gate. Fasten the top
hinge with the appropriate fasteners. Be
sure the hinge stays in contact with the
Nylon washer, and that the gate is level
vertically. (See figure 5)
8. Remove the gate supports used in step 6 to
stabilize the gate. The gate should now be
able to swing freely in either direction.
9. Position the gate where you want it to be
when it is in the
closed
position. Snug the
hex bolts on the either side of the collar and
then back them off ½ revolution. (See
figure 6)
10. Using any 12-volt source attach one of the
wires in the power cable to positive and the
other wire to negative.
a. If there is movement to the gate
note which direction it is moving.
If it is moving in the direction that
you want the gate to move to
open, release the wires from the
power source and reverse the
positive and negative wires and let
the gate move until it stops.
b. If the gate is moving in the
direction opposite what you want
to open the gate continue to run
the gate till it stops.
c. Remove the power source after the
gate stops and manually return the
gate to the closed position. (If the
gate is hard to rotate loosen the
hex bolts in step 9 to allow easier
turning.)
d. If there is no movement when the
power is applied reverse the
polarity of the wires and continue
through steps 10 (a), (b) and (c).
11. With the gate in the closed position tighten
the hex bolts on each side of the gate
(figure 6) at the bottom bracket. (Avoid
over tightening the hex bolts. Over
tightening will cause threads to strip,) Try
the gate again and see if it travels as is
desired. You may need to switch polarity
on the wires to have the gate function.
(NOTE: Electric flows from negative to
positive. The direction of the electric flow
in a 12-volt motor determines the
movement direction of the motor. The drive
mechanisim rotates the gate in one
direction with the 12-volt polarity one-way
and reverses when the polarity is reversed.)
12. Tighten the hex set screws on the collar.
The setscrews can take more tightening
pressure then the bolts at the side of the
collar. (See figure 7)
Top Bracket
Nylon Washer
Figure 5
Pivot Tube
Level
Pivot Tube
Hex Bolt (X2)
(Do not tighten
till step 11)
Gate closed
Figure 6
Tighten setscrews
(x2) securely.
(Setscrews can take
more pressure then
hex bolts)
Figure 7
Hex Bolt (X2)
Gate Installation Instructions