Dietz 720000, Руководство пользователя

Страница: 42 / 152

42
DIETZ GmbH // User manual, XXL products / tauron|dts // Version 1.1 EN
3.4 BACKREST HEIGHT
1. To adjust the backrest height, loosen the
knurled nuts on the side elements and pull
out the bolts (1, Fig. 9).
2. There are three holes for adjusting the
height of the backrest (410/435/460 mm).
To adjust the height, pull both sides of the
backrest up evenly (2, Fig. 9).
3. ÐÐ,K@BÐVLRÐE>SBÐPBQÐFQÐQLÐQEBÐOBNRFOBAÐEBFDEQ Ð
secure the backrest again with the bolts
and knurled nuts. Make sure you insert the
bolts from the front (1, Fig. 10) and that you
fasten the knurled nuts securely on the rear
of the product (2, Fig. 10).
WARNING
1HRJçNEçSQ@OOHMF
ÐBÐ@>OBCRIÐLCÐVLROÐE>KAPÄÐK
gers during assembly.
1HRJç NEç @BBHCDMSç
The product is only to be
used with the backrest securely attached.
2 2
1
Abb. 9
1
1
2
2
Abb. 10
3.5 SEAT DEPTH
You can mount the seat surface in one of two
positions (450/510 mm). The seat depth is mea-
sured from the backrest tube to the front edge
of the seat surface (see Chapter 5.1).
1. Select the seat depth that is right for you
(Fig. 11, 12). Please note that the selec-
ted seat depth also determines where the
hygiene opening is located with the cover
attached to the seat surface.
WARNING
1HRJçNEçSQ@OOHMF
ÐBÐ@>OBCRIÐLCÐVLROÐE>KAPÄÐK
gers during assembly to avoid getting them trap-
ped in moving parts.
1HRJç NEç @BBHCDMS
If you are able to lift the
seat surface up at either the front or the back
following assembly, it means that the plug-in tu-
bes have not been assembled correctly.
1HRJç NEç @BBHCDMS
The plug-in tubes must be
fully inserted and locked with the tube linch pins
before using the product. If thetube linch pins are
inserted from below, they will not lock properly.
3 PREPARING THE PRODUCT FOR USE