Operating Manual Program Timers Variotime Single and Variotime Twin
Diehl AKO Stiftung & Co.KG, Appliance Europe, Pfannerstraße 75-83, DE – 88239 Wangen
Tel. +49 (7522) 73-0 • Fax +49 (7522) 73-250 •
• www.diehl.com/controls/appliance
Subject to change without notice – issued 04-2015 – page 17/20
Follow this procedure to check of change switching points any time.
9.
Having finished, set the right-hand slide switch back to position RUN (24 hour program:
AUTO).
To cancel individual switching points proceed as follows:
10.
Set the right-hand slide switch to position
(Variotime Twin: P1 orr P2).
11.
Press button
repeatedly until the relevant switch on point is selected.
12.
Now press the skip button
and the button
simultaneously for approximately 2 or 3
seconds. The display flashes „0:00“ showing the switching point has been canceled.
13.
Proceed likewise to cancel the linked switch off point to avoid logic errors.
14.
Set the right-hand slide switch back to position RUN (24 hour program: AUTO).
To cancel the entire automatic program use the reset function (see 3.4).
3.4
Reset function
The reset function is recommended for extensive changes in the automatic program. It cancels the
previous input entirely and resets the timer into initial power up status. So a new program can be
created without having to access the individual switching points.
In order to avoid resetting the timer inadvertendly, the button R is recessed and has to be pressed
using a ball pen or similar instrument.
Proceed as follows:
1.
Press the button R. All indications in the display disappear, it flashes “0:00” and the day
indicator at day 1. The automatic program is canceled completely.
2.
Now set the present time of day and the day of the week again as described in 3.1.
Variotime is ready for a new program.
3.5
Skip function
The skip function reverses the current operating mode of the appliance in which Variotime is
installed with immediate effect and is canceled automatically on reaching the next switching point.
It serves to override individual switching points without having to change the automatic program.
