Operating Manual Program Timers Variotime Single and Variotime Twin
Diehl AKO Stiftung & Co.KG, Appliance Europe, Pfannerstraße 75-83, DE – 88239 Wangen
Tel. +49 (7522) 73-0 • Fax +49 (7522) 73-250 •
• www.diehl.com/controls/appliance
Subject to change without notice – issued 04-2015 – page 16/20
•
day block 123456
= daily from Mondays through to Saturdays
•
day block 1234567 = daily from Mondays through to Sundays (7 days a week)
Each pressing of the day button advances the day indicator by one day until day 7 is reached.
Then the day blocks are called up one after the other, resuming again with the single days at day
1.
In the 24 hour version, the 16 switching points are spread over 24 hours only.
In Variotime Twin, the full 16 switching points are available for both channels independently.
The shortest interval between the switching points is 1 minute.
Proceed as follows:
1.
Variotime Single:
set the right-hand slide switch to position
.
Variotime Twin:
set the right-hand slide switch to position P1 (channel 1) or P2 (channel
2). Both channels have to be programmed individually.
The display flashes “0:00”, on the top right the (selected) channel is indicated, on the
bottom right “I” is indicated (switching point 1 ON). The light bulb symbol
appears.
2.
Set the time for the switch on point using the buttons h and m, then assign it to the days
of the week by pressing the day button. The order of the settings is not important.
3.
Pressing the button
advances Variotime to the next switching point 2 (OFF).
The display flashes “0:00”, on the top right the (selected) channel is indicated, on the
bottom right “2” is indicated (switching point 2 OFF).
4.
Set the time for the switch poff point using the buttons h and m, then assign it to the days
of the week by pressing the day button. The order of the settings is not important.
5.
Pressing the button
advances Variotime to the next switching point 3 (ON).
Repeat steps 1 to 4 until all times for switching on and off have been programmed (16
maximum) in the same manner.
6.
Reset the right-hand slide switch to the position RUN (24 hour version: AUTO).
The display reverts to the present time of day and day of the week. Supposing that the left-hand
slide switch is in position AUTO, Variotime immediately executes the program set for the present
time and indicates the status as described above. From now on, Variotime will follow the inputted
automatic program day for day and week for week until the settings are changed.
To check or change switching points proceed as follows:
7.
Set the right-hand slide switch to position
(Variotime Twin: P1 or P2).
8.
Select the individual switching points by pressing the button
repeatedly.