•
6
•
NOTE:
Extended operation of a 12V DC
device may result in excessive battery drain.
Recharge the Portable Power immediately
after unplugging the 12V DC device.
ESTIMATED RUN-TIMES
APPLIANCE
TYPE
EST WATTAGE ESTIMATED
RUN TIME
Cell phone
4 watts
36 hrs
Fluorescent
light
4 watts
36 hrs
Radios, fans
10 watts
16 hrs
Depth finder
10 watts
16 hrs
Camcorder
15 watts
9.6 hrs
Electrical tool
24 watts
6 hrs
Electric cooler
48 watts
3 hrs
Car vacuum,
air compressor
80 watts
1.8 hrs
NOTE:
Actual time may vary. Times are based on
the internal battery being fully charged.
USING THE AIR COMPRESSOR
WARNING:
Read the instructions of the
product being inflated before using the
compressor. Avoid overinflation; do not
exceed the manufacturer’s recommended
pressures. Do not leave the air compressor
unattended during use.
1.
Ensure the battery clamps are securely
on the storage holders.
2.
Remove the air compressor hose from
the storage compartment in the back of
the Portable Power.
3.
Connect the adapter to the valve
stem by threading it onto the end. If
necessary, use one of the additional
adapters.
4.
Place the compressor switch in the ON
position and inflate the product.
5.
When the product is inflated to
the proper air pressure (using the
air compressor gauge) place the
compressor switch in the OFF position
and remove the hose.
6.
Do not run for more than 10 minutes
maximum at a time. Allow the Portable
Power to cool down for 10 minutes
before using again.
NOTE:
To prevent overheating, the
compressor has built-in thermal protection
that will turn the compressor off before it
overheats. If the compressor shuts off,
wait a few minutes and it will automatically
restart when the compressor cools.
NOTE:
The air compressor is rated for
150 PSI.
ESTIMATED TIME FOR INFLATING
Vehicle Tires 13"-16"
5-8 minutes
Bike Tires
1-3 minutes
Sports Balls
30 seconds
These times are approximate. Use the air compressor
gauge to ensure the proper pressure has been reached.
Do not overinflate.
6. MAINTENANCE AND CARE
• Clean the clamps and the case each
time you are finished using it.
• Recharge the unit once a month when
not in use.
• Store clamps on their support posts, to
ensure they do not come into contact
with any metallic surface.
• Never completely discharge the internal
battery.
7. TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
REASON/SOLUTION
The Portable Power won’t
jump start my car.
Clamps are not making
a good connection to the
battery.
Connections are reversed.
The Portable Power’s battery
is not charged.
The vehicle’s battery is
defective.
The Portable Power is not
turned on.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the Portable Power
and reverse the clamps.
Press the Battery Status button
on the front of the unit. The
LEDs will indicate the status of
charge.
Have the battery checked.
Turn the jump start ON/OFF
switch to the ON position.
